PatternAmigurumiBy The Hook Desk22 Aug 2026
Plain amigurumi ball, 7 cm
How do I crochet a plain amigurumi ball that comes out round?
- Hook
- 3.5 mm
- Yarn
- DK / light worsted (#3), approx. 25 g
- Gauge
- 22 sc and 24 rounds = 10 cm, worked in a spiral
- Finished
- 7 cm diameter, 7.5 cm tall
This is the reference shape every other amigurumi piece is a variation on. Worked in DK on a 3.5 mm hook it finishes at 7 cm across and takes about 40 minutes.
Materials
- 25 g DK acrylic or cotton-acrylic
- 3.5 mm hook
- Stitch marker
- Blunt tapestry needle
- About 15 g polyester stuffing
Abbreviations
- sc = single crochet
- inc = 2 sc in the same stitch
- dec = invisible decrease through front loops
- MR = magic ring
- ( ) = repeat the group
Round by round
Open any round to read what happens in it.
R1 · 6 sts
6 sc in a magic ring. Pull the ring closed before starting round 2.
R2 · 12 stsinc
inc in each stitch around (6 inc).
R3 · 18 stsinc
(1 sc, inc) six times.
R4 · 24 stsinc
inc, 2 sc, then (inc, 2 sc) five times, 1 sc. The split keeps the increases off the round-3 spokes.
R5 · 30 stsinc
(3 sc, inc) five times, then 3 sc.
R6 · 30 sts
Plain round. This is the widest point; the ball is 7 cm across from here.
R7 · 30 sts
Plain round.
R8 · 30 sts
Plain round. Stuff to about 60% firmness before round 10.
R9 · 30 sts
Plain round. Top up the stuffing to 90%.
R10 · 24 stsdec
(3 sc, dec) five times, then 3 sc.
R11 · 18 stsdec
(2 sc, dec) five times, then 2 sc.
R12 · 12 stsdec
(1 sc, dec) four times. Stop here — do not go on to 6 stitches.
R13 · 12 sts
Gather: run the tail under the front loop of all 12 stitches, pull closed, and take the needle through the centre into the stuffing.
Finishing
- Weave the starting tail through three stitch posts in two directions to secure the magic ring.
- Roll the finished ball between your palms for 20 seconds to even out the stuffing.
- If the surface looks uneven, mist very lightly and reshape by hand; do not soak a stuffed ball.
If it goes wrong
The ball is taller than it is wide.
Your rows are shorter than 24 per 10 cm. Add one more plain round at round 7 and remove one from each decrease section, or go half a hook size up.
Six ridges are visible running down the ball.
The increases were not staggered. Undo back to round 4 and use the split version given there.
Stuffing shows between stitches.
The fabric is too loose. Go down to 3.0 mm and re-swatch; an empty ball should be opaque held up to a window.